Replacement UV lamp for Hanovia

Mon, 01 Jun 2026 23:54:14 +0800

On an Anatol flash-curing line, downtime isn’t just idle machine time—it’s substrate going in the trash and delivery windows slipping. When the original Hanovia lamp starts to dim, the spectral output shifts, and the photoinitiator response gets lazy. Curing drags, adhesion falls off, and you’re suddenly chasing rejects instead of running the job. Our replacement UV lamp fixes that without rewiring or reprogramming the controls. Here’s the core: we match the original footprint and electrical interface, then rebuild the output where it actually matters. You get stable mercury-vapor spectral output centered at 365nm, with tight control over arc length, bulb diameter, and end-fit geometry. The reflector uses a dichroic coating to manage heat and drive peak irradiance onto the ink, delivering the energy density needed for fast cross-linking. We call out lamp life in actual hours—not marketing—running 5,000+ hours with less than 5% output drop, so your process window stays consistent. The Anatol flash system is a compact, fast curing stage that demands instant-on performance and repeatable dose. This Hanovia-compatible lamp is a direct replacement, so you keep the existing power leads and mounting. The payoff: higher throughput without changing the machine footprint, lower specific energy per cured pass, and fewer lamp-induced color shifts on sensitive ink formulations. One shop-floor reminder: UV lamp output is sensitive to surface cleanliness, so verify the reflector and lamp window are clear of ink residue and oxidation at install. Always handle the lamp by the ends to avoid quartz contamination, and confirm your power supply matches the rated voltage and ignition requirements. Clean starts extend lamp life and keep irradiance stable.

Hanovia on UV Curing Power

Replacement UV lamp for Hanovia